Sunday, August 17, 2008

Summer Camp 2008 is History










Time has slipped by and summer is near its end. Our summer camp has come and gone. I think everyone enjoyed it and we have a few pictures here from camp. The main project was to get the boat finished and launched to complete the Composite Materials Merit Badge and Motorboating. Everyone who wanted to do so completed both of those badges.

Thanks to Brother Vest again, Hno. Olivera, Pablo, Hno. Astorga, Hno Lopez for those great beef ribs, and the dads who were able to come to camp with us at the Colton Springs cabin.

The only complaint I heard of any significance was the lack of a short grass soccer playing field. Next year we will try and make some improvements in that area and more.

Friday, June 20, 2008

Maybe the Prandall?



This evening the epoxy went off very quickly because of the heat. We mixed up some micro balloons, fumed silica and epoxy resin with a drill motor and paint mixer till we got something a little thicker than peanut butter. We then squeegeed it on the taped joints. It is the equivalent of high performance body putty. After this hardens enough, maybe tomorrow, I will start sanding and smoothing to get it ready to cover the entire hull with the synthetic woven material, the Dynel on Weds night. Micky and Jeffrey were here and we got quite a bit accomplished in a short period of time.

We also mixed up some faster setting epoxy and glued three sheets of marine ply together to make the skeg that Hno. Astorga cut for us. We glued them together and then screwed them with some stainless screws until the epoxy hardens. We will then pull the srews out and the holes will be puttied later. The skeg gets laminated aft on the hull. We'll sheath the hull before the skeg goes on. A bunch more putty will make a nice transition with the skeg to the hull. The microballoons make it easier to sand and they assure the putty will be lighter than water, so it adds to the buoyancy. This is all of the structural work on the external seams. Next Weds night we will have the entire hull covered with the Dynel. After that, we will paint several coats of epoxy on to the Dynel and then we can paint it. The boys want red and white and red and white and green. The various national colors for Peru and Mexico respectively. Maybe we will name the boat the 'Prandall', after our friend Paul Randall. We all miss him. There is a fast sailing catamaran named the Prindle so the Prandall sounds like it could be the name of a fine boat.

Thursday, June 19, 2008

More work on the boat...



Miky and I made some great progress with the boat today. Besides doing a dry fit up of the outboard motor mount on the transom and thereby determining we need the long shaft 4 hp Yamaha, we also taped all of the exterior joints with a 12 oz. special bi-axial fiberglass cloth. You cannot see the joints because the glass becomes very clear once the epoxy resin wets it out. We will mix up some epoxy body putty tomorrow and 'fair' all of the joints we taped. Then on Weds we will cover the entire exterior hull with a synthetic glass material called Dynel. It is also woven and tougher against abrasion than fiberglass. Some of you will be attending Trek but the rest of us will work on the boat at 7:00 PM at my house.

All of you will need to do some serious portions of the fiberglass work for the composite materials merit badge. We will have opportunities on the exterior and later in the interior as well.

Saturday, June 7, 2008

Another few hours on the dory


We have completed the exterior sanding and fairing of the hull and are shaping the skeg and keel. The next step will be to tape the seams and glass the entire hull. Keep in mind this is in lieu of covering a cardboard box with fiberglass to make a bird house for our composite materials merit badge. Once we have the hull encapsulated and properly reinforced then we will install the skeg.

Thanks to Javier for fitting the skeg so carefully.

We still need a name for it and have to decide on the colors.

Sunday, June 1, 2008

Trilobite Hunting in the West Desert




We arrived at the dig Saturday morning after a great breakfast of pancakes, eggs and sausage. Friday night we had buffalo burgers on the grill and a moving message around the campfire by Brother Olivera from Alma 30 -- the evidences or signs for the existence of God. A trip into Utah's back country and to gaze into the skies on a clear night confirms to me the beauty of God's creations.

The trilobite hunt was successful and Pablo claims to have found the largest of any that day in the quarry. That may have to be resolved by a side by side comparison. We did find some large trilobites and I think nearly everyone found their ten fossils for the geology merit badge.

We appreciate the fathers and leaders who went with us and helped make the trip possible. Special thanks to Brother Dennis Vest, Martin Gonzales, John Olivera, Pablo Ramos and our Branch President, Jorge Orozco.

Thursday, May 22, 2008

Progress on the Dory



We spent another Thursday evening and got the boat wired together. The next step is to epoxy the interior joints and then we can remove the wire stitches. We may be motoring on a lake later in June.

Monday, May 19, 2008

Composite Materials Merit Badge



This is it, the keel has been laid and the hull is taking shape for our new Boy Scout Troop boat. It is a little over 15' long and will be powered by an outboard motor when we are done. The plywood is a special marine grade and was imported from France. Can we call it 'Freedom Wood'?

When it is completed it will have fulfilled the requirements for our Composite Materials Merit Badge.

Saturday, April 26, 2008

The Poop about Coprolite



On May 31st we are hunting fossils in Shootering Canyon near Hanksville, UT. There are a number of fossils there but the most famous is something called Coprolite. The following is from the blog site of Rick Dalrymple of Rock Pick Legends, a local rock shop in Salt Lake City:

"Coprolite is fossilized dung. It can be from a turtle, dinosaur, camel, birds, lizard, or human.

Utah has loads of coprolites, including dinosaur and human. We are going to talk about the large dinosaur coprolite that comes from the Henry Mountains. The Henry Mountains are located south of Hanksville. They are really a series of 5 mesas and not just one mountain range. They look like typical Basin & Range (or Horst and Groben) type mountains at first. But they were caused by a laccolite rising up, exposing the soft sediment to be weathered away, which in turn exposed all the wonderful fossils. They rise up to almost 12,000 feet above sea level. They are famous around the world as being an anomaly, as they are so young. They cover an area of almost 500 square miles. I think their real beauty is the sight of low rolling hills of faded purple, green, and gray pastels that resemble the bad lands of North Dakota.

The rock that was left exposed contains some of the most stunning fossils recorded. Coprolite in many sizes and colors can be found. I have seen pieces up to 2 feet tall and 3 feet in diameter. Often they look just like a cow pie turned to rock. They don't smell--they are ROCK now.

I have seen coprolite that look just like something your neighbor's dog left on your lawn. I have seen some that are 6 inches long and 2 inches in diameter and resemble a cucumber.

Shitamaring Canyon is famous for coprolites of distinguished shapes. It is also famous for the cycad wood that can be found there. Cycads are a very unusual plant that resembles a pineapple. The trunk of the tree has a hard armor coating of leaf stems that resemble a palm tree. They are not related to palms but look just like them in small hand samples. Ancient cycad has 165 living decedents today include some common house plants.

Whole cycads are usually under 1 foot tall. Complete pieces are incredibly rare and extremely valuable. I have only seen a few in my whole life and none ever for sale. But the most beautiful ones in the world come from this area. When cut along the grain parallel to the skin the insides can reveal a diamond pattern of reds and yellows. These are the best specimens!

The area also has brachiopods, other woods of different colors from black to browns to reds & yellows, dinosaur tracks, gold, and uranium minerals from a very extensive uranium deposit all found right in the canyon.

All of these things would be great to collect still today, but they are now protected in the Escalante Staircase National Monument.

Oh, did I mention in the late 1970's the name of the canyon changed to Shootering Canyon. Many of you are already familiar with this area. It is a fun place to camp and see some unique geology. I think the original name fits the description of the coprolite and the canyon better. Apparently the BLM sign maker disagreed because he was the one that made the sign, giving the canyon it's new name."

Wednesday, March 12, 2008

Elections

We held elections in the troop and reorganized the boys into patrols. Joshua C. is our Senior Patrol Leader. Miky M. and Bruno L. are the Patrol Leaders. Austin F is an Asst. Patrol Leader and Alan M is the Troop Scribe.

We began working on the Fishing Merit Badge and Brother Randall taught the boys how to tie several fishing knots and discussed first aid and low impact fishing including catch and release. Austin and Jorge won the award for the night for the best effort in learning about fishing and tying knots.

Nest week, the 20th we have a combined activity with the YW and attend the musical at Viewmont. The following week we start building our 15' Egret motor boat.

Monday, March 10, 2008

Summer Camp 2008



Summer Camp August 12-16

COLTON GUARD STATION (UT), UT Ashley national Forrest

Description:
This Forest Service cabin is located in the Colton Hollow area, approximately 5 miles west of US Highway 191, near Vernal, UT on the Ashley National Forest. Colton Guard Station was built in 1933 and served as the summer residence for Forest rangers who patrolled the Ashley National Forest on horseback prior to the age of modern vehicles. With the onset of modern vehicles equipped with four-wheel drive, cabins such as Colton became used less frequently for administrative purposes. The Ashley National Forest, Vernal Ranger District, has chosen to rent this Guard Station to the public so that they can enjoy a rustic experience similar to the first rangers. During the warm season (Mid-June to Mid-September), this cabin has running water, a flush toilet, and a shower. The kitchen has all basic amenities including sink, propane stove/oven, refrigerator, table, and four chairs. There is a basic assortment of pots, pans, dishes, and utensils, but bringing your own supplies is always a good idea. There is a combination grill and fire ring located outside. The cabin has a wood-burning stove as a heat source. The operable amenities are an outdoor vault toilet, propane cook stove, and a wood-burning stove for heat. There is one bunk bed (2 twin-size) and one futon (double) in the cabin that will sleep four people. No linens, bedding, or pillows are provided. Level parking is provided for a maximum of 2 RV / camp-trailers. There is ample room for tent camping outside.

Activities: Launching our 15’ boat, Complete our Composite Materials, Woodworking, Motorboating and Fishing Merit Badges. Rank advancements.

Archery contests and shooting. Hiking, Astronomy, Cooking.

Movie night with the digital projector. Cooking, Games, Nature Hikes, Animal Watching, Eating and Sleeping.

We need a $20.00 deposit by July 1 to secure your reservation.